Black and Decker BD08WT6 Manual De Instrucciones página 18

ENGLISH
SET UP & USE
OPERATING INSTRUCTIONS
The unit can be controlled by the unit
control alone or with the remote.
NOTE: The outline of the operation
panel is based on typical model,
the function is the same with
your air conditioner while there
may be some slight differences
in appearance.
TO TURN UNIT ON OR OFF:
Press ON/OFF button to turn unit on
or off.
NOTE: The unit will initiate automati-
cally the Energy Saver func-
tion under Cool, Dry and Auto
modes.
TO CHANGE TEMPERATURE SETTING:
Press UP/DOWN button to change
temperature setting.
NOTE: Press or hold either UP or
DOWN button until the desired
temperature is shown on the
display.
This temperature will be automatically
maintained anywhere between 62˚
F(17˚C) and 86˚F(30˚C). If you want
the display to read the actual room
temperature, see To Operate on Fan
Only section.
SLEEP FEATURE:
Press Sleep button to initiate the sleep
mode. In this mode the selected tem-
perature will increase by 2˚F/1(or 2) ˚C
30 minutes after the mode is selected.
The temperature will then increase
(cooling) by another 2˚F/1(or2) ˚C after
an additional 30 minutes. This new tem-
perature will be maintained for 6 or 7
hours before it returns to the originally
selected temperature. This ends the
Sleep mode and the unit will continue
to operate as originally programmed.
The Sleep mode program can be can-
celed at any time during operation by
pressing the Sleep button again.
Page 18
TO ADJUST FAN SPEEDS:
Press Fan button to select the Fan
Speed in four steps-Auto, Low, Med or
High. Each time the button is pressed,
the fan speed mode is shifted.
CHECK FILTER FEATURE:
Press Check filter button to initiate this
feature. This feature is a reminder to
clean the Air Filter for more efficient
operation. The LED(light) will illuminate
after 250 hours of operation. To reset
after leaning the filter, press the Check
Filter button and the light will go off.
ENERGY SAVER FEATURE:
Press Energy saver button to initiate
this function. This function is available
on COOL, DRY, AUTO (only AUTO-
COOLING and AUTO-FAN) modes. The
fan will continue to run for 3 minutes
after the compressor shuts off. The
fan then cycles on for 2 minutes at 10
minute intervals until the room temper-
ature is above the set temperature, at
which time the compressor turns back
on and Cooling Starts.
TO SELECT THE OPERATING
MODE:
To choose operating mode, press Mode
button. Each time you press the button,
a mode is selected in a sequence that
goes from Auto, Cool, Dry and Fan. The
indicator light beside will be illuminated
and remained on once the mode is
selected.
The unit will initiate automatically the
Energy Saver function under Cool, Dry,
Auto (only Auto-Cooling and Auto-Fan)
modes.
TO OPERATE ON COOL MODE:
Choose Cool Mode to set the cooling
function. Use the Up and Down buttons
to choose the desired temperature.
When Cool Mode is selected, the fan
speed can be adjusted by pressing the
fan button.