Publicidad
Idiomas disponibles
Idiomas disponibles
A10 – Indoor temperature
A11 – Indoor humidity
B – Back view
B1 – Hanging holes
B2 – +(plus) button
B3 – SET button
B4 – -(minus) button
B5 – Battery compartment
B6 – Power adapter cord storage wrap
B7 – Power adapter cord exit
B8 – Stand
B9 – CO2 sensor ventilation
Main features
•
Bold and large displays of time, CO
humidity
•
Coloured display of ventilation recommendation on basis of CO
•
Stable NDIR sensor for CO
•
Wide CO
2
•
Programmable high/low iconic alert of CO
•
Audible CO
•
Smart automatic baseline calibration and manual calibration on CO
•
Light sensor for auto-adjusting brightness of display
•
Built-in memory chip to store settings when power is off
•
Battery backup (for time keeping): 2 x AA batteries (not included)
•
Power supply: 5V~1.5A power adaptor KA0601A-0501200EUS
(included)
•
Wall mounting or table standing
Installation
•
Slide open the battery cover at the back of the clock.
•
Plug in the enclosed 5V-1.5A AC/DC power adaptor to an AC wall
outlet and then the DC jack to the back side of your clock.
•
Optional, for Back-up function only: install 2 x AA batteries by
observing the correct (+) and (-) polarity sign.
•
Replace the battery cover.
Notes:
•
Only use included power adapter KA0601A-0501200EUS
measuring range 400 - 5000 PPM
high / low warning alert
2
level, temperature and relative
2
detection
2
2
EN2
and relative humidity
levels
2
2
Publicidad
