Publicidad
Idiomas disponibles
Idiomas disponibles
LIQUID VACUUM OPERATION
1
6
LIQUID VACUUMING
WARNING:
INFORMATION ENTITLED 'IMPORTANT SAFETY INSTRUCTIONS'. DO
NOT VACUUM IN AREAS WITH FLAMMABLE GASES, VAPORS, OR
EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS
INCLUDE BUT ARE NOT LIMITED TO: LIGHTER FLUID, SOLVENT
TYPE CLEANERS, OIL-BASED PAINTS, GASOLINE, ALCOHOL, OR
AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT
LIMITED TO: COAL, MAGNESIUM, GRAIN, OR GUN POWDER. TO
REDUCE THE RISK OF HEALTH HAZARDS FROM VAPORS OR DUST,
DO NOT VACUUM TOXIC MATERIALS.
WARNING:
POWER OUTLET. MAKE SURE THE PLUG IS DISCONNECTED BEFORE
CHANGING THE FILTERS.
1. Verify that the power cord is disconnected from the outlet. Make sure that the collection tank is
clean and free of dust and dirt (Fig. 1).
2. Remove reusable cloth filter, then carefully install the foam wet filter over the filter cage and place
the powerhead back on the collection tank. For foam wet filter installation instructions, see page 16
(Fig. 2 & 3).
DO NOT USE THE REUSABLE CLOTH FILTER FOR LIQUID VACUUMING.
OPERATING INSTRUCTIONS: WET VACUUMING
3. Insert the larger end of the hose into the vacuum port on the collection tank.
4. Push the required accessory onto the free end of the hose (Fig. 4).
2
3
7
8
BE SURE TO READ, UNDERSTAND, AND APPLY
4
DO NOT PLUG THE POWER CORD INTO A
12
5
Publicidad
