NOTICE! The filters included are made of high-quality materials designed to stop small dust particles.
The reusable cloth filter should be used for dry pick-up only. A dry reusable cloth filter is necessary to
pick up dust. If the reusable cloth filter is wet, it will clog quickly and be very difficult to clean. Handle
the filter carefully when removing it for cleaning and replacing it. Check the filters for tears or small
holes. A small hole can let dust pass through and out of the filter. Do not use a filter with holes or tears;
replace it immediately.
STORAGE
Before storing your vacuum, the collection tank should be emptied and cleaned. The accessories
should be cleaned and stored so they can be readily available when needed. Store the wet/dry
vacuum indoors.
REPAIRS
Repairs for this wet/dry vacuum should be performed only by qualified service personnel using only
identical replacement parts.
INSTALLING & CLEANING REUSABLE
1
INSTALLING REUSABLE CLOTH FILTER
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Remove powerhead and place in an upside-down position.
3. Install the reusable cloth filter over the filter cage making sure the cage is completely covered
(Fig. 2 & 3).
4. Place the powerhead back onto the collection tank.
REMOVING & CLEANING REUSABLE CLOTH FILTER
1. With the removed power head in an upside-down position, carefully remove the reusable cloth filter
from the filter cage (Fig. 4).
2. Clean the reusable cloth filter by gently tapping or brushing dirt off. Cleaning should not be done
indoors in living areas. For optimal performance a new filter is recommended.
3. Use a mild soap and water solution to wash the reusable cloth filter and rinse with clean water (Fig. 5).
4. Allow the wet filter to air dry completely before storing or installing onto the filter cage.
CLOTH FILTER
2
3
4
15
5