Publicidad
Idiomas disponibles
Idiomas disponibles
5. Verify that the switch is in the 'O' OFF position before plugging the power cord into the power outlet.
Plug the power cord into the outlet (Fig. 5 & 6).
6. Turn the motor on by flipping the switch to the 'I' ON position (Fig. 7).
7. Once you have completed vacuuming, flip the switch to the 'O' OFF position and unplug the power
cord from the outlet.
8. After use, empty the collection tank, clean and dry the inside and outside of the collection tank (Fig. 8).
IMPORTANT! When vacuuming large quantities of liquids, do not immerse the nozzle completely in
the liquid; leave a gap at the tip of the nozzle opening to allow air inflow. The machine is fitted with a
float valve that stops the suction action when the collection tank reaches its maximum capacity. You
will notice an increase in motor speed. When this happens, turn off the machine, disconnect from
power supply, and drain the liquid into a suitable receptacle or drain. To continue vacuuming, refit the
powerhead to the collection tank. After wet vacuuming, turn the machine off and remove plug from
power supply. Empty the collection tank, clean and dry the inside and outside before storage.
REMEMBER! The foam wet filter must be removed after wet vacuuming and the reusable cloth filter
must be installed before dry vacuuming again.
1
6
This Wet/Dry vacuum has blowing capabilities. To use the blower feature, follow the instructions listed
below.
WARNING:
WITH ANSI Z87.1 (OR IN CANADA, CSAZ94.3) BEFORE USING BLOWER.
WARNING:
DEBRIS.
BLOWER OPERATION
2
3
7
ALWAYS WEAR SAFETY GOGGLES COMPLYING
KEEP BYSTANDERS CLEAR FROM BLOWING
4
13
5
Publicidad
