Armor All VO405P 0901 Manual Del Usuario página 9

GENERAL ASSEMBLY INSTRUCTIONS
1
6
11
WARNING:
POWER OUTLET. MAKE SURE THE PLUG IS DISCONNECTED BEFORE
ASSEMBLING THE WET/DRY VACUUM. TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT EXPOSE TO RAIN.
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Undo the latches (Fig. 2).
3. Lift the powerhead off the collection tank (Fig. 3).
4. Remove the contents from inside the collection tank. Make sure you have all contents as listed on
page 8 (Fig. 4).
5. Turn the collection tank upside down and insert the four casters into the sockets on the bottom of
the base. Press casters down until they snap into place (Fig. 5).
6. Insert the handle into the slots located on the top of the powerhead (Fig. 6). Apply pressure until
the handle snaps into place.
7. Your vacuum comes ready for dry vacuum cleaning. If the reusable cloth filter is not installed, refer
to page 15 for installation instructions (Fig. 7).
8. For wet vacuum cleaning, remove the reusable cloth filter, and install the supplied foam wet filter.
See page 16 for the foam wet filter installation instructions (Fig. 8).
9. Place the powerhead back on the collection tank aligning the top section with the latches, and
snap into place (Fig. 9 & 10).
10. Insert the larger end of the hose into the vacuum port on the collection tank (Fig. 11).
11. Choose the desired accessory and insert onto the free end of the hose or extension wand (Fig. 12).
2
1
2
7
12
3
8
DO NOT PLUG THE POWER CORD INTO A
9
4
9
10
5