Using The Unit - SPORT-ELEC MULTISPORTPRO PRECISION Manual De Uso

Use of the " " key ( ):
CLEAR
During the program, press the "
The next phase starts unless you have reached the end of the program.
In this case, this key allows returning to selecting the 1
Disconnecting the electrodes during the program :
If an electrode is disconnected, the channel concerned is reset to
During these 30 sec, the electrode(s) can be reconnected, and power restored to the level required.
STEP 7 END OF PROGRAM - STOPPING
At the end of the session, the screen proposes to start a new session by blinking the front muscles to select the 1
Restart the starting procedure if you wish to continue on another muscle zone.
Otherwise, press the " " key ( ) to stop.
ON/OFF
The unit switches to standby after 5 minutes idle.
III. USING THE UNIT
STEP 1
Take the electrodes and remove carefully their protection, dampen them one by one with water on your fingertips on the adhesive
gel, and wait for 2 minutes (diagram I. A, page 2).
STEP 2
Fit the electrodes on your body as shown in diagram II. A or B or C, page 2 : Positions are shown for information only
Important: For optimal use, carefully read each page and look at the examples of use (photos II, page 2).
= connector channel B (middle blue) ;
photo - Chest
1 - Large chest
Do not place the electrodes
close to the heart
STEP 3
Take connector ( ) (photo I. B, page 2) and connect it :
CEV8
1 - to the electrodes (photo I. C, page 2)
2 - then to the unit (photo I. D, page 2).
STEP 4
The unit is connected to the electrodes through the connector, composed of 2 groups of 4 x 1m. long wires completed by 2 groups
of 4 connection plugs.
It is possible to hang your
MULTISPORTPRO
STEP 5
Start your unit following the "Starting the unit" procedure described in paragraph II.
Contractions should be firm but never painful. If you feel an unpleasant sensation around the electrodes : bring the power-on key
back to minimum, move the electrode(s) and gradually increase the power.
Once the adjustments have been optimised in this way, leave your appliance to work for the full duration of the program.
STEP 6
Once the program is complete, disconnect the electrodes from the (
Then pull off the electrodes gently, dampen them slightly with a few drops of water, then return them carefully onto their support.
Store the adhesive electrodes in a fresh location, in a plastic bag (e.g. vegetable container in the refrigerator).
14
" key ( ) during a phase to set its time to zero.
CLEAR
muscle zone (as at normal end of program).
st
Examples of use (photos II, page 2)
= connector channel C (light blue) ; SUP = upper limbs ; INF = lower limbs
B
photo - Shoulders
2 - Medium deltoid
3 - Posterior
4 - Anterior
to your clothing using the clip.
and blinks for 30 sec, before returning to a fixed
C
9 - Upper trapezius
10 - Medium trapezius
) connector, then the latter from the unit.
CEV8
.
st muscle zone.
photo - Trapezius