Using The Unit - SPORT-ELEC MULTISPORTPRO MSPRO4M Manual De Instrucciones

CHOOSE THE WARM-UP PHASE AND
4
Only for categories 02 to 07.
The screen proposes a warming-up phase before starting the active phase of the program.
f f
The WARM-UP PHASE pictogram blinks in the top right corner.
To select it, press , otherwise press the key and validate
Then the ALT / SIM pictogram blinks.
f f
To select ALT, press the key, then validate
To select SIM, press the key, then validate
If you have selected the warm-up phase, SIM is displayed when starting the program, as the warm-up phase is only in the
simultaneous mode.
The pictogram for the program category chosen is lit, the muscle zone(s) chosen blink alternately.
The screen is displayed:
- the battery level,
- the phase duration (countdown in minutes),
- the timer pictogram,
- the ALT or SIM option and warm-up phase if you have selected them.
LAUNCHING THE START - ADJUSTING INTENSITY
5
You must press the buttons matching the cables to the pads (or to the accessories) for starting a program.
For increasing the intensity level and changing the strength of the stimulation, press 11 times to move to the next level.
The intensity level(s) is/are displayed at the bottom of the screen. Do not start a program if the battery level is low.
The intensity ranges vary during the session according to the program.
Warning! The unit is equipped with a security system that locks the launch of a program if the electrode pads are not
placed correctly on the skin.
PROGRAM PERFORMANCE
6
Use of the (Clear) key
f f
During the program, you can press the
The next phase starts unless you have reached the end of the program.
In this case, this key allows returning to selecting the 1
Disconnecting the electrodes during the program
f f
If an electrode is disconnected, the channel concerned is reset to
During these 30 sec, the electrode(s) can be reconnected, and power restored to the level required.
END OF PROGRAM - STOPPING
7
At the end of the session, the screen proposes to start a new session by blinking the front muscles to select the 1
Restart the starting procedure if you wish to continue on another muscle zone.
Otherwise, press the key to stop.
The unit switches to standby after 5 minutes idle.
III. USING THE UNIT
A. USING THE DEVICE WITH THE BELT
The belt has 2 pairs of snap fasteners onto which 2 wireless electrodes specially designed by SPORT-ELEC® are clipped.
To obtain new electrodes, contact your usual retailer or order them from our website www.sport-elec.com.
Warning!
Never use the belt without attaching the 2 electrodes provided.
Only use electrodes supplied by SPORT-ELEC®.
PRESENTATION OF THE BELT :
1 = Snap fasteners
2 = Wire storage flap
(with a lopp fixing device)
3 = Scratch strip
- USER MANUAL
/ OPTION
(it disappears from the screen).
.
key to cancel the ongoing phase.
muscle zone (as at normal end of program).
st
and blinks for 30 sec, before returning to a fixed .
muscle zone.
st
1
2
1
3
15