Publicidad
Idiomas disponibles
Idiomas disponibles
• As a precaution after a disc change, allow the prod-
uct to run for 60 seconds at maximum speed. Pay
attention to any unusual noises or sparks.
• Check whether all fastening parts are attached cor-
rectly.
• Make sure that the direction of rotation arrow (if
present) on the cutting or roughing wheels* (includ-
ing diamond cutting wheels*) and the direction of ro-
tation of the product (direction of rotation arrow on
the product head) match.
8
Operation
WARNING
Danger of injury!
Remove the battery from the power tool before carry-
ing out any work on the power tool (e.g. maintenance,
tool change, etc.) and when transporting and storing
it. There is a risk of injury if the on/off switch is oper-
ated unintentionally.
ATTENTION
Make sure that the ambient temperature does not ex-
ceed 50°C and does not fall below -20°C during work.
ATTENTION
The product is part of the 20V gomag series and may
only be operated with batteries of this series. Batter-
ies may only be charged with battery chargers of this
series. Observe the manufacturer's instructions.
8.1
On/Off switch (1) (Fig. 1)
ATTENTION
Before use, check the inserted tool to ensure all fas-
tening parts are attached correctly.
Note:
Always switch the angle grinder on before making con-
tact with the material and then guide the product to the
workpiece.
Note:
If the product blocks due to overload and switches off, it
restarts automatically as soon as the cause of the
blockage is no longer present (auto-start function).
Switching on
1. Push the ON/OFF switch (1) forwards to switch the
product on.
28 | GB
CAUTION
Always switch the product off after the work and wait
until the grinding disc has come to a complete stand-
still before placing the product down.
Switching off
1. To switch off, release the on/off switch (1).
8.1.1
Switching on continuous operation
1. Push the ON/OFF switch (1) forwards to switch the
product on.
2. Then also press the on/off switch (1) down at the
front until it engages.
Switching off continuous operation
1. Press the on/off switch (1) down at the back and
then release it.
8.2
Adjusting the speed
Note:
The speed can also be changed during operation.
The speed can be preselected with the setting wheel
for speed preselection (2):
1 =
lowest speed, e.g. for surface machining:
Grinding, polishing
6 =
highest speed, e.g. for cut-off grinding
We recommend determining the speed using practical
tests.
The speed that makes sense when working depends
on what tasks you are doing with the product.
When cut-off grinding, the use of a high speed is usual-
ly not a problem. When sanding or polishing the surfac-
es, a low speed is better.
9
Working instructions
Note:
Grinding bodies may only be used for the recommend-
ed applications. Otherwise, it could break, be damaged
or cause injuries.
ALWAYS replace the grinding wheel if the product has
been dropped during work.
A grinding or cutting wheel must NEVER be knocked or
banged against the workpiece.
Especially when working on corners, sharp edges, etc.,
make sure that the grinding wheel does not jump or get
stuck. This could cause loss of control and setbacks.
NEVER use the tool with wood cutting or other saw
blades. Such saw blades, when used on a grinder,
cause frequent kickback and loss of control, which can
lead to injury.
www.scheppach.com
Continuous operation
Publicidad
