Sanctuary Reserve SA-PLAT-2-D Manual De Instrucciones página 8

4. ELECTRONIC LOCK SECURITY CODE SETUP
Important: Your safe comes programmed with a factory code of [ 1 5 9 # ]. It is necessary
to re-program your safe with a new security code you have personally selected to provide
maximum household security. Be careful in choosing your new security code, you'll want
to be sure that you can operate the unit quickly without making an error.
To begin programming, open and extend
1.
locking bolts while the door is open
during programming.
On the inside of the safe door,
locate the brass cap. Unscrew and
remove the cap, giving access to the
reset button. Press the reset button.
You will hear 2 beeps and the touch pad
will illuminate indicating that you are
now in programming mode.
2.
Enter your new 3 to 8 digit
security code followed by the
[ * ] symbol.
If programming is is successful: touch
pad will beep 2 times and green
unlock LED will flash 2 times.
If your code was not accepted: the
touch pad will beep three times and
the yellow lock LED will flash 3 times.
Press the reset button and start again.
Inactivity Timeout: If this programming sequence is not completed within 10
seconds the red LED will flash 3 times and the touch pad will shut down.
Return to step 1 to restart this process.
Confirm new code while the safe door is still
3.
open.
• Swipe finger(s) across the keypad to activate
the lock face. Two random numbers will
illuminate. Press them in any order
• Enter your newly programmed code followed by
the (#) symbol.
If successful you will hear two beeps and the
green unlock LED will flash 2 times. You will then
be able to retract the bolts. If unsuccessful,
repeat programming.
NEW 3-8 DIGIT SECURITY CODE
SUCCESS!
x2
CONFIRM SECURITY CODE
x2
GREEN
7