Publicidad
Idiomas disponibles
Idiomas disponibles
5. OPENING SAFE WITH PROGRAMMED SECURITY CODE
With keys in hand, close and lock the door.
NOTE: Be certain the spoke hub is rotated
completely counterclockwise.
Swipe finger(s) across the touch pad to "wake up"
and activate the lock face.Two random numbers
will illuminate when the touch pad wakes up.
Individually press the two numbers, in any
order, to allow full access to the touch pad.
Next, enter your security code followed by the ( #) button.
If the security code is accepted,
the yellow lock LED will flash 2 times followed by the
green unlock LED illuminating. You now have access to your safe.
If the security code is rejected,
the yellow lock LED will flash 3 times and beep 3 times.
*Now that your security code is successfully programmed, store your override
keys in a secure secondary location. If you are not able to open your safe with your new
programmed code, repeat section 4 to program a new security code.
6. TROUBLE SHOOTING
PROBLEM
You lock face is not lighting up or
your lock is not disengaging.
The handles will not rotate
clockwise to unlock after
entering your code and getting
the green light.
7. LOCKED OUT OF YOUR SAFE
In the event you are locked out of your safe, use your override keys to gain access and
follow the steps in Section 4: Electronic Lock Security Code Setup Instructions.
If you have lost your override keys, or are still having difficulties, contact customer
service at the number below. Proof of purchase is required to obtain keys.
Contact Customer Service at cs@saproducts.com or (888) 792-4264
SOLUTION
Make sure batteries are fresh. We suggest high grade
alkaline. Do not mix old and new batteries. Do not use
rechargeable batteries.
Rotate the handles counter-clockwise until it will not
rotate and then try entering your code again. You
should then hear a 'click' and be able to rotate the
hub clockwise to unlock your safe.
1
2
3
4
8
5
6
7
#
9
0
*
8
Publicidad
