Publicidad
Idiomas disponibles
Idiomas disponibles
14
EN
Potential-free contacts are provided for the controlinputs
of the machine. Connect the corresponding wires to
the terminal as shown in the illustration. There are
three different input signals:
▪ DH: Request for air dehumidification
▪ TC: Request for air dehumidification with cooling
▪ VENT: Request for continuous fan operation
The REHAU control system NEA SMART 2.0 can be
used to control the dehumidifier. For correct connection
and correct use, observe the relevant technical
information and the locally applicable regulations.
If required, the REHAU actuator UNI 230 V, which is
assigned to the water circuit of the dehumidifier, can
be connected to the terminals of the ZONE VALVE
output signal. When using an on-site actuator, please
ensure that the nominal data of this actuator match
the output signal 230 V AC 1 A Max of the
dehumidifier.
Use separate cables for the power supply, the input
signals and the output signal and the cable glands
provided at the factory for this purpose. If three cable
glands are required for this, an additional cable gland
must be installed on site at the location of the cable
grommet. The factory-fitted cable glands are suitable
for cables with an outer diameter of 6 – 12 mm.
Before using the unit, the electronics box cover must
be properly closed again.
03.05
Installing the grille
Preparing the grille
The following steps must be carried out to attach the
four brackets to the back of the grille:
1
Position the bracket in the recess provided on the
1
back of the grille and secure it using a threaded bolt.
Ensure that the bracket bends inward and the hooks
point down.
2
Adjust the bracket to the correct position.
2
3
Fasten the bracket using the wood screw.
3
830
830
17
Side and rear views of the grille
Publicidad
