Publicidad
Idiomas disponibles
Idiomas disponibles
To allow the grille to be fixed to the wall using a screw,
a hole must be drilled in one of the lower corners of
the grille using a suitable wood drill. Note the diameter
and the position of the hole as shown in the following
illustration.
Preparing the wall
Place the grille over the metal case and mark out the
drilling location on the wall.
Remove the grille again and drill a hole using a drill
suitable for the wall material and the enclosed screw.
Then use a suitable wall dowel.
ø 5
20
Positioning the grille DHU W-G
Once the unit is properly connected, the grille can be
fitted. Replace it and screw in place using the screw
provided for this purpose. The enclosed cover cap can
then be placed on the screw head.
The dehumidifier may only be used if the grille is
properly secured using the enclosed screw.
Handle the grille carefully to avoid damage and
chipping.
The white colored cover grille is not suitable for
painting over.
The grille can be fitted to the installed metal case
regardless of whether the dehumidifier is present.
Ensure that the grille is aligned correctly. The part of
the grille on the back of which the air filter is located
must be positioned in the lower part of the dehumidi-
fier in front of the fan. The grille filter must be cleaned
regularly. Refer to chapter 04.04.
15
EN
Publicidad
