Publicidad
Lock Button:
NOTE: It is strongly recommended to use this feature to avoid any unexpected/unintentional
movement.
1. Press this button to lock the touch-screen. This will prevent accidentally engaging the controls after
the desired height has been set. Press the button again to unlock the touch-screen.
2. To reset your desk to default settings, press and hold this button while simultaneously plugging in the
power cord until the control panel lights up.
3. To change between inches and centimeters, press and hold this Lock button for 5 seconds.
Display:
1. The display will indicate the height of the desk (inches). After five seconds without input, the digital
readout will automatically fade away.
2. Touch and hold one of the memory buttons (H1-H3) for 3 seconds when the desk is at the desired
height in order to save it as a memory preset. The desk will automatically return to the set height
when the corresponding memory button is touched.
3. Touch and hold the
The desk is at the lowest height setting when "bot" is displayed.
4. Touch and hold the
The desk is at the highest height setting when "top" is displayed.
USB Port:
There is 1 USB port suitable for charging devices with 2.4A charging power requirement (or lower).
The USB port will pause charging temporarily when the height of the desk is being adjusted and the
motor is in use.
USB-C Ports:
There are 2 USB-C ports suitable for charging devices with 1A charging power requirement (or lower).
These USB-C ports will pause charging temporarily when the height of the desk is being adjusted
and the motor is in use.
GetActive™ Timer Button
1. Touching the timer button will cause the digital readout to blink. Use the Up button
through the timer settings: 00, 10, 15, 30, 45, 60, 75, 90, 105, 120. Use the Down button
through the timer settings: 120, 105, 90, 75, 60, 45, 30, 15, 10, 00. Touch the timer button again to
confirm and start the countdown.
2. When the timer button is touched, the digital readout will display the remaining time. For example,
120, 119, 118, 117......05, 04, 03, 02, 01, 00). If the desk's height is adjusted during the countdown, the
readout will show the height and return to the timer afterwards..
3. When the countdown is finished, the desk will beep 5 times continuously in 3 successions and
remain stationary.
ODP720 UKREV1.0
OPERATION
Control Panel
button to lower the desk and release when it arrives at the desired height.
button to raise the desk and release when it arrives at the desired height.
1 USB Port (5V/2.4A)
2 USB-C Ports (20V/1A for each port)
Lock Button
18
to cycle
to cycle
Publicidad
