Publicidad
Step 12
1
å
Pull the DRAWER FRONT BRACKETS (7G) apart and slide them into the grooves in the
DRAWER SIDES (D40 and D41). You may need to gently tap them in with a hammer.
å
NOTE: The DRAWER FRONT BRACKETS are marked "RH" and "LH" for easy identification.
å
Fasten the DRAWER FRONT (F) to the DRAWER FRONT BRACKETS (7G). Use two BLACK
9/16" LARGE HEAD SCREWS (1S).
2
D959
U n fi
n i s h
s u r
e d
f a c
e
D40
F
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (D959) into the
grooves in the DRAWER SIDES (D40 and D41) and
DRAWER FRONT (F).
Page 16
F
D40
3
With the palm of
your hand, tap
the DRAWER
BOTTOM down
into the groove.
D40
D41
å
429626
Push down
7G
D41
D154
D41
Fasten the DRAWER BACK (D154 ) to the DRAWER
SIDES (D40 and D41). Use four BLACK 1-9/16" FLAT
HEAD SCREWS (30S).
11
BLACK 9/16" LARGE HEAD SCREW
(2 used in this step)
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
(4 used in this step)
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
www.sauder.com/service
1S
Publicidad
