Publicidad
Hardware Usage Guide
HOW TO USE A HIDDEN CAM & CAM DOWEL
Cam Dowel
Arrow
Metal end
Hidden Cam
3.
Caution
Risk of damage or
injury. HIDDEN CAMS
must be completely
tightened. HIDDEN
CAMS that are not
completely tightened
may loosen, and parts
may separate. To
completely tighten:
Step 1
å
Assemble your unit on a carpeted floor or on the empty
carton to avoid scratching your unit or the floor.
å
Push four HIDDEN CAMS (1F) into the ENDS (A and B).
Then, insert the metal end of a CAM DOWEL (2F) into
each HIDDEN CAM.
2F
Metal end
www.sauder.com/service
Start
Arrow
Arrow
1F
1.
Push a HIDDEN CAM into
the part. The arrow in the
HIDDEN CAM must point
toward the hole in the
edge of the board.
Look for this icon. It means a video assembly tip is
available at www.sauder.com/service/tips
Find the numbered video or scan the QR code.
Do not tighten the HIDDEN CAMS in this step.
B
429626
2.
Insert the metal end of the CAM
DOWEL into the HIDDEN CAM.
Hole
Tighten
Arrow
Maximum
210 degrees
Minimum
190 degrees
A
1
Page 5
Publicidad
