Schumacher Electric SL1517 Manual Del Usuario página 12

PROBLEM
When cable is connected only
to the battery: Solid Red LED,
(Green LED off).
When cable is correctly
connected to both battery
and jump starter: Green LED
blinking; Red LED off; no beep.
Smart Cable LED and Alarm Behavior
BEHAVIOR
Green LED blinking; Red LED
off; no beep.
Green LED solid; Red LED off;
no beep.
Solid Red LED, Green LED off;
beeps once per second
Solid Red LED, Green LED off;
beeps twice per second
Alternating Red and Green
flashing LEDs; no beep
Solid Red LED, Green LED off;
rapid beeping
Solid Red and Green LEDs;
no beep.
Solid Red and Green LEDs;
beeps once per second
NOTE: When the condition is corrected, the smart cable will automatically reset.
11. SPECIFICATIONS
Internal battery type .......................................... Lithium ion polymer
Capacity .............................................................................. 29.6 Wh
USB input .......................................................................
USB output ................................................... Standard: 5V DC, 2.4A
Jump start ......................................................................1200A peak
Charging Temperature..................................... 32 ° -122 ° F (0 ° -50 ° C)
The vehicle battery voltage is lower than
10.5V. User can connect to jump starter
and turn key to jump start the vehicle.
"Fake" high battery voltage is detected,
but reverse charging protection did not
activate. User can turn key to jump start
the vehicle.
Cable is connected to battery only.
Cable is connected to jump starter only.
Cable is connected correctly to both
battery and jump starter.
Low voltage protection
Reverse polarity protection
Reverse charging protection
Short circuit protection
Auto shut-off, due to inactivity. Disconnect
and reconnect clamps to the vehicle battery.
Temperature protection
USB Fast Charging: 5V, 3A / 9V, 2A / 12V, 1.5A
• 12 •
SOLUTION
REASON
USB, 2A