Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Before adjusting the pulverising nozzle's pressure (high-to-low or low-to-high) release trigger.
Anti-impurities filter
This model includes a transparent male connector with an anti-scale filter to which the hose is
connected, preventing scale from building up.
5. CLEANING AND MAINTENANCE
Disconnect the appliance from the power supply and allow it to cool down before cleaning.
Use a soft, damp cloth to clean the product's surface.
Do not immerse the appliance in water or other liquid.
Do not use abrasive scouring pads, powders or cleaners.
Maintenance of the water filter
Remove the transparent cover of the filter, then remove the dirt in the filter and rinse the parts
with water. Put the transparent cover back.
Cleaning and preservation
Remove the water inlet and the hose before storing it. Pour out the water inside the device and
the hose.
Remove the battery and store it separately if the device is not going to be used for a long time.
6. TROUBLESHOOTING
Problem
Cause
ECO indicator light flashes.
Low battery.
The device does not turn on.
Low battery.
Sudden power outage.
Temperature too high,
overheating protection.
Low water content.
Filtering blockage that leads
to a poor water intake.
Inlet hose bent.
Water contains impurities
40
HYDROBOOST 10000 LIBERTY
HYDROBOOST 10000 LIBERTY
Solution
Charge the battery.
Charge the battery.
Turn the device again once
the temperature is lower.
Clean the water inlet's filter
and the water inlet.
Replace or straighten the
inlet hose.
Replace the water.
The device does not absorb
Water inlet's leakage.
the water
Poor connection between
water inlet and water inlet's
connector.
The water inlet's filter is not
correctly assembled.
The device takes longer to
Device on Energy-saving
absorb water.
mode.
Multi-function nozzle leaks.
Multi-function nozzle is not
correctly assembled.
Multi-function nozzle leaks.
The nozzle is not correctly
assembled.
Why can't I charge the battery?
Why does the battery's charging time change?
7. TECHNICAL SPECIFICATIONS
Product reference: 05406
ENGLISH
Tighten the inlet's joint.
Reassemble the inlet and
outlet accessories.
Assemble it correctly.
Deactivate ECO mode and
switch to normal mode.
Insert the multi-function
nozzle in the device and then
rotate it.
Rotate the nozzle to the
indicating mark.
Check if the charger and the battery are
compatible.
The battery can only be inserted into the
charger in one direction.
Turn the battery until it can be inserted into
the charger. When the charger's indicator light
turns red, it means it is charging.
The charging time is affected by many factors,
but this does not mean the device is defective.
If the battery is only partially discharged, it
will take less time to charge it back.
If the battery's temperature and the room
temperature are low, the battery will take
longer to charge.
If the battery is too hot, the overheating-
protection system will disconnect the device
automatically. If this happens, unplug the
device from the socket and the battery from
the charger and then start charging it again
after it cools down.
41
HYDROBOOST 10000 LIBERTY
HYDROBOOST 10000 LIBERTY
Publicidad
