Greencut GGT200L Guía De Mantenimiento página 49

MAINTENANCE
CLEANING GUIDE
Caution: Disconnect the battery before performing any cleaning, maintenance or repair.
Clean the mower thoroughly after each use with a cloth or brush. Do not spray with water and
keep hands away from the moving head.
•
Wear gloves when cleaning, do not clean with unprotected hands.
•
Clean the machine after each use to ensure best performance and durability.
•
Make sure all vents designed for heat dispersal are clean and free of obstructions or debris.
•
Remove grass clippings, dirt, etc. from the underside of the deck and blades (the wash
function on some models makes this task easier).
•
It is recommended to put a little oil on the blades after each use to prevent blade corrosion.
•
Make sure that all hoppers and covers are clean and free of obstructions.
•
Make sure that spring-loaded terminals, such as the rear cover, spring back into place when
released.
•
Clean and check the collection basket for damage and replace damaged parts as required.
Allow the collection basket to dry completely before storing to prevent deterioration or
rotting.
•
Make sure all cables, levers, switches, etc. are clean and operate as they should and without
problems.
Note: Use a slightly damp cloth, water and a mild detergent for cleaning. Do not use solvents,
chemicals or harsh abrasives as this may damage some plastics and/or surfaces. For parts that are
difficult to access, use a brush.
SPOOL REPLACEMENT
2
1
1
1. Press firmly on the two tabs of the reel cover.
2. At the same time, pull the cover to remove it.
3. Remove the reel cover. If necessary, clean the area first.
4. Extend the nylon thread.
5. Insert the new spool in place.
6. Pass the ends of the nylon thread through the holes.
7. Press firmly on the two tabs of the spool cap at the same time, and push the cap onto the
spool until it clicks into place.
49
4
4
3
7
5
6
EN - GGT200L