Publicidad
Idiomas disponibles
Idiomas disponibles
B5.
MOUNT THE OVEN
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND THAT TWO PEOPLE
INSTALL THIS OVEN.
IMPORTANT: Do not grip or use handle
during installation.
NOTE: If your cabinet is metal, use the nylon
grommet around the power cord hole to prevent
cutting of the cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not
used, case damage may occur from over
tightening screws.
NOTE: When mounting
the oven, thread power
cord through hole in
bottom of top cabinet.
Keep it tight throughout
Steps 1–3. Do not pinch
cord or lift oven by
pulling cord.
2 Rotate front of oven up
against cabinet bottom.
Insert a self-aligning screw through top center
3
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after the
threads have engaged. (It will be completely
tightened later.) Be sure to keep power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to bottom of cabinet.
Installation Instructions
Lift oven, tilt it
1
forward, and hook
slots at back bottom
edge onto two lower
tabs of mounting plate.
Cabinet Front
Attach the oven to the top cabinet.
4
Insert 2 self-aligning screws
5
through outer top cabinet
holes. Turn two full turns on
each screw.
Tighten the outer two screws to the top of the
7
oven. (While tightening screws, hold the oven
in place against the wall and the top cabinet.)
Install grease filters. See the Owner's Manual
8
packed with the oven.
18
Cabinet Bottom Shelf
Filler Block
Equivalent
to Depth
of Cabinet
Recess
Self-Aligning Screw
Oven Top
Tighten center
6
screw completely.
Publicidad
