Publicidad
Step 7
å
Separate the EXTENSION SLIDES (U) from the EXTENSION RAILS (T) as shown in the upper diagram
below. Be prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (T) to the ENDS (A and B). Use four GOLD 5/16" FLAT HEAD SCREWS (3S).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide
the inner cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the END.
Turn a SCREW into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWER.
Push the black lever in and pull the SLIDE from the RAIL.
Open end
T
www.sauder.com/service
U
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
B
P
3S
Open end
T
A
428192
7
T
H
Page 11
Publicidad
