Publicidad
Step 14
å
Carefully stand your unit upright.
å
Push two DOOR STOPS (4I) into the holes in the BOTTOM (E).
å
Before fastening the DOOR to your unit, be sure the mounting
screw is against the stops as shown in the right diagram. If it
isn't, loosen the mounting screw to slide it against the stops.
Then tighten the mounting screw.
å
Fasten a DOOR (K) to the LEFT END (B) as shown in the lower
diagram. Use the screws in the HINGES. You should start each
SCREW a few turns before completely tightening any of them.
å
Fasten a KNOB SET (136K) to the DOOR (K). Use a
BLACK 1-1/8" MACHINE SCREW (21S).
å
Repeat this step for the other DOOR (K).
å
See the next step for DOOR adjustments.
136K
BLACK 1-1/8" MACHINE SCREW
(2 used for the KNOBS)
Page 18
K
21S
B
E
4I
428192
17
Pro Tip: Lift with your
legs. And, you know,
your arms.
Stop
Mounting
screw
Hinge
www.sauder.com/service
Publicidad
