Publicidad
Step 2
Step
å
Fasten the BRACE (D) to the ENDS (A and B). Turn four
1/2" HEX HEAD SCREWS (5) a few turns using the
L-WRENCH (2). Do not completely tighten the SCREWS at
this time.
å
Peel the PADS from the PAD CARD (1) and apply to the
bottom edge of the ENDS (A and B) as shown.
1/2" HEX HEAD SCREW
(4 used in this step)
B
Page 6
5
2
D
www.sauder.com/service
Just think. The sooner
you do this, the sooner
you do something else.
1
A
429446
Publicidad
