Publicidad
Step 4
Step
å
Fasten the MOLDINGS (C) to the TOP (G). Turn six 2" HEX
HEAD SCREWS (3) a few turns using the L-WRENCH (2). Do
not completely tighten the SCREWS at this time.
å
Fasten the ENDS (A and B) to the TOP (G). Turn six 1/2" HEX
HEAD SCREWS (5) a few turns using the L-WRENCH (2).
å
Now, completely tighten all of the SCREWS in your unit.
1/2" HEX HEAD SCREW
(6 used in this step)
Page 8
C
B
5
2
www.sauder.com/service
G
C
2" HEX HEAD SCREW
(6 used in this step)
A
3
429446
Publicidad
