Publicidad
Step 5
å
Lay the ENDS (A and B) flat on the floor with the HIDDEN CAM surfaces down.
å
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into the ENDS (A and B) until the shoulders of the SCREWS rest on
the surfaces of the ENDS.
å
NOTE: Do not overtighten the SCREWS.
å
Slide the MOLDINGS (C) onto the ENDS (A and B). Line up the grooves in the MOLDINGS over the heads of the SCREWS
in the ENDS.
å
NOTE: If the MOLDING comes up off of the SCREWS, remove it and slide it on again.
RIGHT END ASSEMBLY
These edges
should be even.
LEFT END ASSEMBLY
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
Page 10
A
C
Shoulder
C
These edges
should be even.
428191
BLACK 9/16" FLAT HEAD SCREW
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
32S
32S
(4 used in this step)
Shoulder
B
www.sauder.com/service
Publicidad
