Publicidad
Step 19
å
Flip a drawer over onto the left DRAWER SIDE (D225).
å
Diagram 1. Insert the tabs on a DRAWER STOP (20G) into the slots in a EXTENSION SLIDE (45MC). You may need
to insert one tab first, then the other.
å
Diagram 2. Visually check that the DRAWER STOP (20G) is seated in the EXTENSION SLIDE (45MC).
å
Diagram 3. If the DRAWER STOP is not seated, use your hammer to gently tap the SLIDE until the tabs are properly
seated in the slots.
å
Now, fasten the EXTENSION SLIDE (45MC) to the right DRAWER SIDE (D225). Use two GOLD 5/16" FLAT HEAD
SCREWS (3S) through holes #2 and #4.
å
Repeat this step for the other drawer.
1.
20G
These tabs must
insert into the slots.
Post
2.
45MC
Page 24
Slot
3
4
D225
D225
20G
Seated
428191
Open end
1
2
GOLD 5/16" FLAT HEAD SCREW
3.
7
3S
(4 used in this step)
www.sauder.com/service
Publicidad
