Publicidad
Step 8
å
Diagram 1. Measure 1-1/2" from one end of the INTERLOCK TRACK (22G). Position the INTERLOCK TRACK as shown.
å
SAFETY STOP / TRACK ATTACHMENT:
å
Diagram 2. Tilt the first edge of the INTERLOCK TRACK (22G) into the SAFETY STOPS (29G).
å
Diagram 3. Rotate the INTERLOCK TRACK and apply force to snap the second edge into the SAFETY STOP.
å
Diagram 4. Repeat the SAFETY STOP / TRACK ATTACHMENT for the next SAFETY STOP while holding the previously
completed SAFETY STOP in its location hole. Repeat these steps until all STOPS have been attached. Visually check
that all INTERLOCK TRACK edges have been snapped into the SAFETY STOPS as shown in diagram 3.
å
Diagram 5. Remove the INTERLOCK TRACK assembly from Diagram 4 and flip it over before inserting the INTERLOCK
TRACK (22G) with SAFETY STOPS (29G) into the groove in the RIGHT END (A).
Be sure the
interlock track
snaps into each
SAFETY STOP.
5.
www.sauder.com/service
The interlock system is a safety feature
that prevents more than one drawer
from opening at the same time. Do not
use excessive force to open the drawers.
A
22G
A
428191
22G
4.
29G
22G
2.
4
1.
Tape Measure
22G
3.
29G
Page 13
Publicidad
