Publicidad
Step 9
å
Separate the EXTENSION SLIDES (45MC) from the EXTENSION RAILS (45MA) as shown in the enlarged diagram
below. Be prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (45MA) to the ENDS (A and B). Use eight GOLD 5/16" FLAT HEAD SCREWS (3S)
through holes #1 and #3.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL out to find the other hole that lines up with the hole in the END. Turn a SCREW
into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
45MC
Push the black lever in and pull the SLIDE from the RAIL.
1
Open end
Page 14
4
3
2
B
2
1
45MA
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
2
3
4
A
4
3
After fastening the EXTENSION RAILS to the RIGHT END (A),
the SAFETY STOPS should touch the top edge of the RAILS.
If the gap is larger than 1/16", the drawers could lock up and
not open. If this happens, open two drawers at the same time
to override the interlock system. Remove the drawers to
re-adjust the INTERLOCK TRACK assembly.
428191
3S
1
1
2
3
4
www.sauder.com/service
7
Open end
SAFETY STOP
Publicidad
