Publicidad
Step 3
å
Refer to the enlarged diagram to identify the parts on the HINGES.
å
The DOORS may need some adjustments. Follow the text below to make needed adjustments.
å
DOOR ADJUSTMENTS:
To adjust the DOORS from side to side (horizontal), turn the adjusting screw in or out.
å
To adjust the DOORS up and down (vertical), remove the round hole screws and loosen the slotted hole screws. Move the DOORS up
or down to the desired location. Tighten the slotted hole screws first. Then turn the round holes screws into their holes.
å
To adjust the DOORS in or out (depth), loosen the mounting screw one turn and move the DOORS in or out, as needed.
Tighten the mounting screw after making adjustments.
426292
Mounting screw (depth)
Adjusting screw (horizontal)
www.sauder.com/service
17
(vertical adjustment)
4 screws
Page 7
Publicidad
