Publicidad
Idiomas disponibles
Idiomas disponibles
9
Operation
The cordless impact drill with 2-gear transmission has a
25 level torque adjustment +1 screw setting +1 drill set-
ting +1 hammer-drill setting, clockwise/anticlockwise ro-
tation, quick-release chuck and an LED work lamp.
Please refer to the following descriptions for the func-
tion of the controls.
WARNING
Danger of injury!
Remove the battery from the power tool before carry-
ing out any work on the power tool (e.g. maintenance,
tool change, etc.) and when transporting and storing
it. There is a risk of injury if the on/off switch is oper-
ated unintentionally.
ATTENTION
Make sure that the ambient temperature does not ex-
ceed 50°C and does not fall below -20°C during work.
ATTENTION
The product is part of the 20V gomag series and may
only be operated with batteries of this series. Batter-
ies may only be charged with battery chargers of this
series. Observe the manufacturer's instructions.
9.1
Inserting/removing the battery (5)
in the battery mount (6) (Fig. 2)
Inserting the battery
1. Put the rotational direction switch (10) in the middle
position (lock).
2. Push the battery (5) into the battery mount (6). The
battery (5) clicks into place audibly.
Removing the battery
1. Press the unlock button (7) of the battery (5) and re-
move it from the battery mount (6).
9.2
Check the charge status of the
battery
The charge status indicator (28) indicates the charge
status of the battery (5).
The charge status of the battery is indicated by the cor-
responding LED light lighting up.
1. Press the charge status indicator button on the bat-
tery (27).
LED on the battery
Charging status
red-orange-green
Battery full
red-orange
Battery partially charged
red
Battery empty
28 | GB
9.3
Depleted batteries
• A significantly shortened operating time despite
charging indicates that the battery has been used
up and needs to be replaced. Only use original re-
placement batteries.
• In any case, observe the applicable safety instruc-
tions as well as regulations and instructions on envi-
ronmental protection (see "Disposal and recycling").
9.4
Charge battery
Charge the battery at an ambient temperature of 4 °C
to 40°C.
1. Push the battery (5) into the battery mount (6) as far
as it will go.
2. Plug the mains plug into the socket.
As soon as the charging process starts, the green
LED (14) flashes.
3. LED (14) lights up green when charging is com-
plete. The battery (5) is ready for use.
ATTENTION
–
If the red LED flashes, the battery has overheated
and cannot be charged.
–
IF the red and green LEDs flash, the battery is de-
fective.
4. Pull the battery (5) out of the battery holder (6).
5. Wait at least 15 min until a new charging process.
Therefore, pull the mains plug out of the outlet.
9.5
Inserting/removing the tool
attachment
WARNING
Tool attachments may be sharp and become hot
during use. Always wear protective gloves when han-
dling the tool attachments.
CAUTION
Keep your hands away from the tool attachment
when the product is in operation.
1. Turn the quick-release chuck (2) anti-clockwise until
the chuck opening (1) is large enough to insert the
tool attachment.
2. Insert the tool attachment into the quick-release
chuck (2) as far as possible.
3. Turn the quick-release chuck (2) clockwise to clamp
the tool attachment tight.
4. To remove the tool attachment again, untwist the
quick-release chuck (2) and remove the tool attach-
ment.
www.scheppach.com
Publicidad
