Descargar Imprimir esta página

Scheppach gomag GO-CSK74/2 Traduccion Del Manual De Instrucciones Originale página 32

Taller movil incl. atornilladora- taladradora de percusion de bateria, 2x baterias de 2ah + cargador

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Notes on lithium-ion batteries
Remove the battery before disposing of the
device!
• Do not dispose of the battery in household waste, in
a fire (risk of explosion) or in water. Damaged bat-
teries can harm the environment and your health if
toxic vapours or liquids escape.
• Defective or used batteries must be recycled in ac-
cordance with Directive 2006/66/EC.
16 Troubleshooting
Fault
The product cannot be started. The battery power is too weak.
17 Warranty conditions – gomag
20V series
Revision date 11/07/2023
Dear customer,
our products are subject to strict quality checks. How-
ever, if a product does not function perfectly, we deeply
regret this and ask that you contact our customer ser-
vice at the address specified below. We will also be
glad to assist you by telephone via the service number.
The following information is intended to help you to pro-
cess and settle your claim without any problems.
For the assertion of warranty claims, the following
applies:
1. The warranty conditions govern our additional
manufacturer warranty services for purchasers (pri-
vate end consumers) of new products. The statutory
warranty claims are not affected by this warranty.
This is the responsibility of the dealer who you pur-
chased the product from.
2. The warranty service extends exclusively to de-
fects in a new product purchased by you that are
based on a material or manufacturing fault and is, at
our discretion, limited to the repair of such defects
free of charge or the replacement of the product (al-
so replacement with a successor model, if neces-
sary). Replaced products or parts shall become our
property. Please note that our products were not
designed for commercial, trade or professional use.
A warranty claim is therefore not valid if the product
has been used in commercial, trade or industrial op-
erations within the warranty period or has been sub-
jected to equivalent stress.
32 | GB
Possible cause
The battery is not properly inserted. Push the battery into the battery mount. The
The direction of rotation switch is in
the centre position.
www.scheppach.com
• Hand in the device and the battery charger at a re-
cycling centre. The plastic and metal parts used can
be separated by type and thus recycled.
• Dispose of batteries when discharged. We recom-
mend covering the poles with an adhesive strip to
protect against a short circuit. Do not open the bat-
tery.
• Dispose of batteries according to local regulations.
Return batteries to a used battery collection point
where they can be recycled in an environmentally
friendly manner. Ask your local waste disposal com-
pany about this.
Remedy
Charge the battery.
battery clicks into place audibly.
Push the direction of rotation switch to the left
or right.
3. The following are excluded from our warranty
services:
– Damage to the product which was caused by
non-observance of the assembly instructions, im-
proper installation, non-observance of the operat-
ing instructions (e.g. connection to an incorrect
mains voltage or type of current) or the mainte-
nance and safety regulations or use of the prod-
uct in unsuitable environmental conditions as
well as by insufficient care and maintenance.
– Damage to the product caused by misuse or im-
proper application (such as overloading the
product or using non-approved tools and acces-
sories), penetration of foreign bodies into the
product (such as sand, stones or dust), trans-
port damage, use of force or external influences
(such as damage caused if dropped).
– Damage to the product or parts of the product
which is due to intentional, normal (operational)
or other natural wear as well as damage and/or
wearing of wear parts.
– Defects in the product which have been caused
by the use of accessories, expansions or spare
parts that are not original parts or are not used
as intended.
– Products on which changes or modifications
have been made.
– Minor deviations from the target characteristics
which are irrelevant for the value and usability of
the product.
– Products on which unauthorised repairs have
been carried out, in particular by an unautho-
rised third party.

Publicidad

loading

Este manual también es adecuado para:

39093069982