PREPARE THE HOOD
NON - DUCTED CONFIGURATION,
cont'd.
8. Carefully place the lower decorative flue
into the recessed area of the range hood
top. Fig.7
9. Carefully slide the upper decorative
flue
down inside the lower flue.
Note: air vents must be up. Fig.7
lO.Secure
the recirculation
plenum to the
upper flue with (4) flat head screws. Fig.9
INSTALL THE HOOD
4 FLAT
HEAD
SCREWS
(3.4x15
ram)
UPPER
FLUE
Note: at least two people will be required to
mount the hood.
1. Raise
the hood into its
mounting position.
2. Plug the power cord into
the electric
wall recep-
tacle. Tuck excess cord
behind the flue.
3. Align
the
rectangular
opening on the back of
the hood with the wall-
mounting bracket. Gently
lower the hood
until it
securely
engages
the
bracket.
Fig.lO
4. Level the hood.
HEIGHT
ADJUSTMENT
SCREWS
MOUNTING
SCREWS
1
fig.9
MOUNTING
BRACKET
MOUNTING
SCREWS
(4.8x38mm)
RECTANGULAR
CUTOUT
Height
adjustment
screws
provide
vertical adjustment.
Secure the hood with mounting
screws
(4.8x38mm).
Use
drywall
anchors,
provided, if wall studs or framing are not
available.
Secure
with
(2)
mounting
screws
(4.8x38mm). Use drywall anchors provided
if wall studs or framing are not available.
Fig.10
5. Raise the upper flue until its holes align
with holes in the flue mounting bracket
(located on ceiling). Fig.11
6. Secure the flue with (2) mounting screws
(3.9x9.5mm).
Fig.11
_._WITHFASTEN
FLUE TO
UPPER
BRACKET
SCREWS
fig.lO