Danfoss OPTYMA Plus Manual De Instrucciones página 2

Instructions
Optyma Plus
™
OP-MPXM
Name plate
OP-MPXM125MLP07E
A
114X4405
B
Application MBP
C
D Refrigerant (1) R404A/R507/R448A/R449A
R407A/R407F/R452A
E M.W.P. HP (1) 28 bar
M.W.P. LP (1) 7 bar
F
Voltage 400 V ~ 3N ~ 50Hz
LRA 95 A
OIL INSIDE POE 46
G Serial No. 123456CG1221
xxxxxxxxxxxxxx
EAN No.
A: Model
B: Code number
C: Application, Protection
D: Refrigerant
E: Housing Service Pressure (Maximum
working pressure)
F: Supply voltage, Locked Rotor Ampere,
Maximum Current Consumption
G: Serial Number and bar code
Picture 2 : Stacked mounting
2 | AN37374141535501-010101 - 118A2984A
MADE IN INDIA
Y
IP 54
(2) R134a
R513A
(2) 23 bar
(2) 5 bar
MCC 20 A
Picture 1 : Minimum mounting distances
Danfoss A/S, 6430 Nordborg, Denmark
V
U
V
Q
W
Z
R
X
T
U
T: Mounting brackets for stacked mounting (not supplied)
U: M8 bolts for stacked mounting (supplied)
V: Mounting bolts (not supplied)
The condensing unit must only be used for its
designed purpose(s) and within its scope of ap-
plication.
Under all circumstances, the EN378 (or
other applicable local safety regulation)
requirements must be fulfilled.
The condensing unit is delivered under nitro-
gen gas pressure (1 bar) and hence it cannot
be connected as it is; refer to the «installation»
section for further details.
The condensing unit must be handled with cau-
tion in the vertical position (maximum offset
from the vertical : 15°)
Installation and servicing of the condensing
units by qualified personnel only. Follow
these instructions and sound refrigeration
engineering practice relating to installation,
commissioning, maintenance and service.
© Danfoss | DCS (CC) | 2021.11