EBERTH OE1-12V50LBS Instrucciones De Uso página 42

Fixing the motor, adjusting the angle and length of the motor below the water surface
Loosen the screw and adjust the
height of the shaft (3),p.1 1 to adjust
the length of the motor under water.
Do not overtighten this screw to avoid
accidental damage to the fibreglass
shaft.
Put the motor (E),p.13 onto the motor
mount on your boat with the clamp
bracket.
EN V. 1.0
Press the lever (4),p.1 1, to release the spring.
Then you can tilt the axle to adjust the angle
or take the motor out of the water. After the
change, release the lever again and the
motor remains in the desired position.
Tighten these two screws (5),p.1 1
to secure the engine to the out-
side board of the boat.
fig. 9
17