Beko BEVPG 090 Manual De Instrucciones página 39

8 Indoor unit installation
Drain hose must be on bottom
Make sure that the drain hose is at the bottom of
the bundle. Putting the drain hose at the top of the
bundle can cause the drain pan to overflow, which
can lead to fire or water damage.
Do not intertwine signal cable with other wires
While bundling these items together, do not
intertwine or cross the signal cable with any other
wiring.
2. Using adhesive vinyl tape, attach the drain hose
to the underside of the refrigerant pipes.
3. Using insulation tape, wrap the signal wire,
refrigerant pipes, and drain hose tightly together.
Double-check that all items are bundled.
Do not wrap ends of piping
When wrapping the bundle, keep the ends of the
piping unwrapped. You need to access them to
test for leaks at the end of the installation process
(refer to Electrical checks and leak checks
section of this manual).
Step 8: Mount indoor unit
If you installed new connective piping to the
outdoor unit,do the following:
1. If you have already passed the refrigerant piping
through the hole in the wall, proceed to Step 4.
2. Otherwise, double-check that the ends of the
refrigerant pipes are sealed to prevent dirt or
foreign materials from entering the pipes.
3. Slowly pass the wrapped bundle of refrigerant
pipes, drain hose, and signal wire through the
hole in the wall.
4. Hook the top of the indoor unit on the upper
hook of the mounting plate.
Split type air conditioner / User Manual Split type air conditioner / User Manual
5. Check that unit is hooked firmly on mounting
by applying slight pressure to the left and right-
hand sides of the unit. The unit should not jiggle
or shift.
6. Using even pressure, push down on the bottom
half of the unit. Keep pushing down until the unit
snaps onto the hooks along the bottom of the
mounting plate.
7. Again, check that the unit is firmly mounted by
applying slight pressure to the left and the right-
hand sides of the unit.
39
39 / 324 EN / 334