Publicidad
Idiomas disponibles
Idiomas disponibles
4 OPERATING INSTRUCTIONS
4.1 INSTRUMENT DESCRIPTION
4.2 KEYBOARD
LED "STATUS" blinks every time the START/STOP key is pressed.
5 INITIAL SETTINGS
5.1 DATE, TIME AND MEASURING INTERVAL
It's possible to set measuring interval as well as date and time by using the management
software. This program enables to:
➢
Set the measuring interval
Control data and time of the instrument's internal clock
➢
➢
Set instrument date and time.
➢
Check battery status
How to operate:
1. Connect the instrument to PC COM using included serial cable.
2. Run TopView software and open the "PC-Instrument Connection" section
3. Perform the detection of the instrument by using the "Find the instrument" or
"Autoset" keys
4. Select the "Configure the instrument" command and press the "Next" key in order to
set date/time in the instrument and the measurement interval in the "Integrated
Period" field selecting values 1s, 6s, 30s, 1min or 5min
5. Confirm with "Send" command.
• The instrument could keep the data stored even without batteries
• The set date and time don't get lost provided that the battery replacement
takes less than 2 minutes.
Fig. 1: Instrument description
CAUTION
EN - 6
XL423 - XL424
CAPTION:
1. Phase voltage Inputs
2. COM input
3. "STATUS" LED
4. "ALARM" LED
5. RS232 port
6. START/STOP key
Publicidad
