Publicidad
Idiomas disponibles
Idiomas disponibles
5. How to start a Recording:
• If no recording was performed or if the recording data had been already downloaded
to a PC, press the START/STOP key for 3 seconds. The STATUS LED will be
lighting for the same time, than will become stable for 1 second and the instrument
will start recording.
• If the recording data had not been already downloaded to a PC and the operator
wants to overwrite these data, press the START/STOP key for 6 seconds. The
STATUS LED will quickly blink for the same time during key pressing, then the LED
will become stable for 1 second and the instrument will start recording. The old
recording will be deleted and overwritten by the new one. The instrument will
wait for the next minute beginning (second=00) and the STATUS LED will double
blink. After that the recording starts and the STATUS LED will blink every 3 seconds.
The instrument is storing the data.
6. During a Recording:
• A 3 second blinking of STATUS LED means that the recording is active and the
instrument is storing the data.
• A 3 second blinking of ALARM LED means that the batteries are low. During a
recording any RS232 communication is possible.
• During Recording operations RS-232 serial communications to PC are not
possible.
7. Stop a Recording:
• To stop a Recording press START/STOP key and keep it pressed for 3 seconds.
The STATUS LED will quickly blink three times and the instrument will stop the
recording and then stop blinking.
For more details about blinking of STATUS and ALARM LED meanings, please refer to the
§ 7.
EN - 12
XL423 - XL424
Publicidad
