Publicidad
PASO 8
Dividiendo el extrusor
Release both M3x40 screws at the front, just below the extruder motor. Don't
remove them completely. We will use them to hold the extruder parts together.
Carefully split the extruder apart by pulling the front out.
Create approx. a 1cm (0.5in) gap similar to the one seen in the picture.
PASO 9
Desmontaje parcial del extrusor
Reach for the hotend and incline its upper part towards the motor. Wiggle it to slide
it down.
If the hotend is still stuck inside, release the screws below the motor some more to
increase the gap between the printed parts.
BE EXTRA CAUTIOUS with the hotend cables!!! You can break them! Use a
reasonable force to pull the hotend out. Don't bend the cables too much.
9C. Extrusor MK3S+ (UPG)
Ensamblaje Original Prusa MMU3
131
Publicidad
