Publicidad
PASO 8
Test de Carga (parte 2)
While your MK3S+ loads a filament into the extruder, it performs the loading check:
Solid blocks should be generated on the bottom of the LCD representing the IR
filament sensor detecting a filament during the process.
If there are lines instead of some of the solid blocks, it means the Filament
sensor in the extruder is providing an intermittent reading and might require
some aditional tuning.
En caso de que fallen varios reintentos de carga, aparecerá una
error
correspondiente.
On the MK3.5 / MK4 printer, you can check the filament sensor's status in the
"footer" area of the LCD screen to see if it's detecting the filament correctly.
PASO 9
Calibración del eje Z y de la primera capa (opcional)
IMPORTANT: This step is necessary for the MK3S+ / MK3.5 if you worked on the
extruder head previously. If you only upgraded the old chimney to the new one, you
can skip to the next step and use the Live Adjust Z function as usual to fine-tune
the first layer.
Go to LCD Menu - Calibration - Calibrate Z.
A continuación, ejecuta la
204
11. Primer comienzo
Calibración de la primera
Ensamblaje Original Prusa MMU3
pantalla del
capa.
Publicidad
