Publicidad
PASO 25
Spoolholder-to-Buffer PTFE tube
Connect the PTFE tubes from the MMU unit to the BOTTOM row of collets on the
buffer, ensuring you match the numbering on both the buffer and the MMU unit.
Attach each end of the PTFE tube from the Buffer to the PTFE holder on each
Spool holder.
Make sure each spool holder is hooked up to the corresponding filament
position number. (marked 1 to 5 on the MMU unit and the buffer.)
There have been several versions of buffer parts available, which might look slightly
different. However, the assembly process remains the same.
The MMU3 for MK4 necessitates the use of the latest version of the buffer
components. If you're using an older version, it's essential to rebuild the device
using the most recent version available.
10A. Configuración y Calibración MK4
Ensamblaje Original Prusa MMU3
157
Publicidad
