Publicidad
PASO 24
Spoolholders setup
Congratulations! The hardest part is over.
The Buffer and spools setup in the picture is the one we will be trying to achieve.
Arrange the spool holders and the buffer as seen in the picture.
Hook up the "printer holder" part on the buffer to the extrusion on the printer.
The PTFE tubes should go from the spoolholders to the buffer. Then, from the
buffer to the back of the MMU.
Note the spool holder positioning. It is important that filament has as straight path
as possible and that nothing interferes. PTFE tubes should not be bent too much.
Otherwise, the filaments will jam.
There were multiple versions of the spool holder available with the MMU3. Refer to
one of the pictures, depending on your spool holder version.
156
10A. Configuración y Calibración MK4
Ensamblaje Original Prusa MMU3
Publicidad
