Publicidad
Idiomas disponibles
Idiomas disponibles
Brush installation
Automatic brush attachment, (Fig.21):
raise the machine head by pushing the head lift pedal down and to the
the head. Lower the head by pushing the head lift pedal down and to
the right, turn the selector to the "OFF" position, press the "SET" button
once then press the "+" button, the machine will complete the attachment
brush on the scrubber drier.
Automatic brush release
(Fig.22):
raise the machine head by pushing the head lift pedal down and to the
left, turn the selector to the "OFF" position, press the "SET" button once
then press the "-" button, the machine will complete the release sequen-
ce.
1
3
PUSH
SET
21
1
3
PUSH
SET
22
Lifting and transporting the machine
! WARNING
All phases of lifting and moving must be performed in an adequately
illuminated environment with the adoption of the safety measures
most appropriate to the situation.
The operator must always use personal protection devices.
Proceed as follows to load the machine onto a means of transport:
Empty the tanks.
Remove the batteries.
Quick head change
The scrubber head can be changed as described below.
Removing the head:
Installing the head:
2
SET
4
SET
PUSH
2
SET
4
SET
PUSH
Filling the water/detergent tank
When using the Severe Environment device, the solution tank must
EN
Push the machine onto the pallet using a sloping ramp, securing
the front wheels and the chassis using the brackets supplied.
The machine must not be raised.
Lift the pallet (with the machine) using a fork lift truck and load it
onto the means of transport.
Anchor the machine to the means of transport with cables con-
nected to the pallet and to the machine itself.
Lower the head.
Electrically disconnect the head from the machine's wiring, dis-
and disconnecting the motor connector/connectors.
Remove the head.
Perform the procedure described previously but in the reverse
order.
3
! WARNING
Do NOT put detergent solution into the tank.
! WARNING
Do NOT put detergent into the tank.
5
1
2
13
Publicidad
