SAFETY INFORMATION
Safety precautions
! DANGER
Read the "User Manual" carefully before start-up and use or before
performing maintenance or any other work on the machine.
! WARNING
Rigorously follow all the instructions in this Manual (in particular
those marked "Danger!" and "Warning!"). Also respect the labels
applied to the machine (see the "Safety symbols" chapter.
The Manufacturer declines all liability for injury to persons or dam-
age to property resulting from failure to follow instructions.
Only one operator may operate the machine.
The machine must be used exclusively by persons trained in its
use and/or who have demonstrated their ability and have been
expressly authorised to use it.
The machine must not be used by minors.
Always pay attention to other people, especially children, in the
place where you are working.
Children must be supervised to make sure they do not play with
the machine.
The machine is not intended for use by persons (including chil-
dren) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they are supervised
by a person responsible for their safety and have received in-
struction in the use of the machine.
The machine must not be used for purposes other than those for
which it was expressly designed.
Scrupulously respect all safety standards and conditions ap-
plicable to the type of building in which the machine is to be
operated (e.g.: pharmaceutical companies, hospitals, chemical
companies, etc.).
This machine is intended for use in commercial applications,
such as hotels, schools, hospitals, factories, shops and com-
mercial premises.
The machine must only be used indoors.
Warning, the machine must be kept indoors at all times.
The machine is designed for use at temperatures of between
+4°C / 39.2°F and +40°C / 104°F. When the machine is not being
used, the temperature range is +0°C / 32°F and +50°C / 122°F.
The machine is designed to operate at relative humidity levels
between 30% and 95%.
The machine must operate at altitudes below 2000 m / 6561.68
ft.
When the tank needs to be lifted to access the compartment, its
accidentally closing again.
! DANGER
Use caution when raising/lowering the tanks to avoid the potential
risk of crushing, be careful of pinch points.
uids (e.g. petrol, fuel oil, etc.), acids or solvents (e.g. paint sol-
vents, acetone etc.) even if diluted.
Do not use the machine in inadequate lighting, explosive atmos-
pheres, on public roads, to clean dirt that is hazardous to health
(dust, gas, etc.) or in unsuitable environments.
Never clean up burning or incandescent objects.
Never use to clean on slopes or ramps steeper than those mar-
ked on the machine.
Never use on slopes or ramps steeper than those marked on
the machine..
If using the machine on gentle slopes, never drive sideways,
rather keep the vehicle parallel to the direction of the slope.
Always manoeuvre with care and avoid reversing.
Never park the machine on a slope.
Never leave the machine unattended with the motor on. Before
dentally by disconnecting it from the power supply and removing
the electronic key.
Never use the machine to transport people or goods or to tow
things.
Do not tow the machine.
Never rest objects of any weight on the machine for any reason.
Never obstruct the ventilation and heat dispersion openings.
Never remove, modify or circumvent safety devices.
Numerous unpleasant experiences have shown that a wide
range of personal objects may cause serious accidents. Before
beginning work, remove jewellery, watches, ties, etc..
The operator must always use personal protection devices:
protective apron or overalls, non-slip waterproof shoes, rubber
gloves, protective goggles and ear protectors and mask to pro-
tect the respiratory tract.
and warnings on the product labels.
Do not use detergents that may produce hazardous reactions,
vapours, heat, etc.
Keep hands away from moving parts.
Never wash the machine with water jets.
Make sure the electrical characteristics of the machine (voltage,
frequency, power) given on the nameplate correspond to those
of the mains electricity supply.
Make sure the power sockets used for battery chargers and
mains powered models are properly earthed and protected by
ers. In the event of a malfunction or failure, the earth connection
EN
2
1
2
3
-
-
-