Hitachi G 14DBL Instrucciones De Manejo página 9

GUARANTEE
We guarantee Hitachi Power Tools in accordance with
statutory/country specifi c regulation. This guarantee does
not cover defects or damage due to misuse, abuse, or
normal wear and tear. In case of complaint, please send
the Power Tool, undismantled, with the GUARANTEE
CERTIFICATE found at the end of this Handling instruction,
to a Hitachi Authorized Service Center.
Information concerning airborne noise and vibration
The measured values were determined according to
EN60745 and declared in accordance with ISO 4871.
Measured A-weighted sound power level: 90 dB (A).
Measured A-weighted sound pressure level: 79 dB (A).
Uncertainty K : 3 dB (A).
Wear hearing protection.
Vibration total values (triax vector sum) determined
according to EN60745.
Surface grinding:
a
Vibration emission value
Uncertainty K = 1.5 m/s
2
SPECIFICATIONS
Model
Voltage
Rated speed
Outer dia.
Wheel Hole dia.
Thickness
Peripheral speed
Wieght*
* Weight: According to EPTA-Procedure 01/2003
Mode
No-load
Auto
During operation
Transmission
Dial Settings
(G18DBVL)
h , AG = 12.2 m/s
2
G14DBL
14.4 V
Auto mode: 5500 min
115 mm 125 mm
2.3 kg
Status
1
2
3
4
5
6
The declared vibration total value has been measured in
accordance with a standard test method and may be used
for comparing one tool with another.
It may also be used in a preliminary assessment of exposure.
WARNING
○ The vibration emission during actual use of the power
tool can diff er from the declared total value depending in
the ways in which the tool is used.
○ Identify safety measures to protect the operator that
are based on an estimation of exposure in the actual
conditions of use (taking account of all parts of the
operating cycle such as the times when the tool is
switched off and when it is running idle in addition to the
trigger time).
NOTE
Due to HITACHI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
G18DBL
9000 min
-1
-1
115 mm 125 mm 115 mm
22.23 mm
6 mm
80 m/s
Table 3
Number of Revolutions (min
5500
9000
4700
5500
6400
7200
8100
9000
9
G18DBAL G18DBVL
18 V
Transmission mode:
4700 – 9000 min
Auto mode:
5500 min
125 mm 125 mm
2.4 kg
-1 ) Use
Light work, Standby state
Grinding, cutting
Grinding stainless steel
Rust or paint removal
Grinding, fi nishing
Rough grinding, cutting
English
-1
-1