Diagram For Test Without Alternator - WEG AVR-A-OPT-07 Manual De Instalación, Operación Y Mantenimiento

17.

DIAGRAM FOR TEST WITHOUT ALTERNATOR

Below is the diagram for regulator connection on the bench where the equipment operation may be verified before
connection to the alternator.
Material required:
1 - Small screwdriver;
1 - Incandescent lamp;
1 - Lamp socket;
1 - Circuit breaker (Three-phase 10A recommended);
1 - Extension cable;
1 – Transformer 1Kva Ratio [Vn / 220Vac].
NOTE
1. After performance of such steps as per the procedure the equipment must be sent for evaluation by WEG
technical support.
1º. Mount circuit as per diagram below;
2º. With small screwdriver, turn trimpots Vad counter-clockwise until the end of stroke;
3º. Turn on circuit breaker:
4º. Turn slightly the trimpot Vad clockwise (the lamp must shine after certain position of trimpot)
5º. With lamp on, turn slightly the trimpot Vad counter-clockwise (after certain position of trimpot, the lamp must turn off);
6º. Turn off the circuit breaker.
Automatic Voltage Regulator – AVR-A-OPT-07 / AVR-A-OPT-07E / AVR-A-OPT-07/T l 23
www.weg.net