Publicidad
Idiomas disponibles
Idiomas disponibles
of the signal, and the speaker will change the pitch with the change in signal
strength.
When the tip of the receiver reaches the break position, the signal strength shown
by 9 and 6 will have an obvious drop until they finally disappear.
At this time, press the receiver's MANUAL key 8 to engage manual mode and
then use the 9 and 10 keys to reduce the sensitivity as much as possible while
ensuring that the receiver's display 8 can show the code transmitted by the
transmitter. This zone will be where the interruption is located.
SUGGESTIONS
1.
Full contact with the earth must be assured.
2.
Adjust the transmitter transmit power level to suit different detection radii.
The best way is to mark the break position on the other side of the wall.
Press the MANUAL key on the receiver to turn on manual mode. Press
keys 9 and 10 to reduce the sensitivity and ensure that the signal can be
received. Trace the signal in front of the wall with the receiver until it is no
longer indicated. The position of the interrupt can be located by this
setting.
3 APPLICATION DETAILS 3.1
Application of a pole
18
Cable locator
Publicidad
