Pride Mobility Pursuit 2 Manual De Usuario página 26

V. C O M F O R T A D J U S T M E N T S
To install the positioning belt (if required):
1. Remove the seat from your scooter.
2. Place the seat upside down so that you can see the bottom of the seat base. See fi gure 16.
3. Use a wrench to remove the two rear bolts on the outermost part of the seat frame.
4. Insert the bolt through the appropriate ends of the positioning belt and then reinstall the bolts back into the
seat frame.
5. Tighten the bolts.
Metal tab style positioning belt
To adjust the positioning belt for operator comfort:
1. Insert the metal tab on the right side of the belt into the plastic housing on the opposite strap until you hear a
"click." See fi gure 17.
2. Pull the strap on the right side of the belt until it is secure, but not so tight as to cause discomfort.
To release the positioning belt:
1. Press the push button mechanism on the plastic housing.
MANDATORY! Make sure the positioning belt is properly secured to the scooter and is adjusted
for operator comfort before each use.
MANDATORY! Inspect the positioning belt for loose parts or damage, including tears, worn spots,
bent hardware, or damaged latch mechanisms, dirt or debris, before each use of the scooter. If
you discover a problem, contact your authorized Provider for maintenance and repair.
Figure 16. Positioning Belt Bolts
26
Figure 17. Positioning Belt - Metal Tab Style
SC7132