Zoeller 1084-0001 Manual Del Usuario página 7

INSTALLATION INSTRUCTIONS
1. Make sure the sump basin is cleared of any
debris or sediment, and place pump on a hard
surface inside the basin.
2. Connect the discharge pipe, fittings and check
valve to pump discharge. The discharge pipe
should be the same size as the discharge of
pump (1-1/2-in) or larger.
NOTE: Make sure there is enough room in the
basin for the float to move freely. If the float is
restricted, the pump will not operate.
3. Make sure your hands are dry and you are
not standing in water. Connect the pump to a
properly-grounded, GFCI electrical outlet.
WARNING: Do not use an extension cord.
NOTE: Tape or tie the electrical cord to the
discharge pipe to prevent it from interfering with
the motion of the float.
1
2
3
7
© 2023. All rights reserved.
IL2042
Discharge pipe
and ttings
Check
valve
3/16 in.
vent hole
115 V
IL2043
GFCI Outlet