Pahlen LED 170AP Manual Del Usuario página 10

LED Lighting Element 170AP
Start up
First check that the lights are installed correctly
Manual sync of the RGB lights:
1. Activate the synchronization of the multi-coloured lamp programs by switching on the lights, check if all lights are on.
2. Switch off the power supply to the lamps and wait at least 20 seconds.
3. Switch on and off again twice.
4. Switch on the lights. Now all lamps are in the same program mode (program 1).
5. When the lights are synchronized keep their setting until a light is replaced or switches off separately.
Changing the colour/program:
Change program by rapidly switching on and off the lights again. The lights shift to the next program (1-14, see below).
Memorizing the last color/program:
Select the desired colour/program. Turn the lights off, wait at least 20 seconds. The selected program is now stored.
Program Name
1. Deep blue sea
2. Daylight blue
3. Sunset
4. Love is in the air
5. Forest spring
6. Think pink
7. Sunshine
8. Jungle beach
9. Voodoo
10. Disco
11. Party
12. Warm white
13. Neutral white
14. Sun white
Frost Risk
Always power off the lamps before a possible winter closure. For the lights not to freeze, we recommend the following:
1. Loosen the front ring.
2. Unclip the lightning element from the gasket.
3. Let the light gently fall to the bottom of the pool (hanging in the cable).
Troubleshooting
Problems Solution
Lights indicate Check that all lights are correctly connected to the same transformer and via the common power
different colour/ switch according to the schematics.
program Carry out synchronization under "Manual sync" above.
Flickering light • Switch on the lights. RGB lights: Select the sun white colour.
• Remove bulb from water. Loosen the nut and pull back the seal to access the brass connector inside
the connector (do not remove the connector).
• Measure the voltage at the bulb terminals (while the lamp is still on). The correct value should be at
least 10VAC 50/60Hz. If it is less: Check the voltage at the transformer. It should be between 12VAC
and 14VAC. Check that the transformer has adequate capacity to operate all connected lights.
If the transformer's voltage if fine, a thicker cable may be needed between the transformer and light.
Waste management and recycling
This product is disposed of in accordance with local laws and regulations. As this product contains electrical components, it must
be disposed of separately from household waste. When this product reaches the end of its life cycle, contact local authorities to
find out more about waste management and recycling.
Type Colour
Fixed Deep blue
Fixed Light blue
Fixed Orange red
Fixed Red
Fixed Green
Fixed Pink
Fixed Yellow
Slow shifting Deep blue, light blue, azur blue, mid blue and light blue
Slow shifting Red, wine red, purple and bordeau
Fast shifting Puple, pink, peach, light yellow, light green and light blue
Fast shifting Blue, azur blue, green, green/red, red blue, purple, light pink, peach, yellow,
light green and light blue
Fixed Warm white
Fixed Neutral white
Fixed Sun white
10
ENGLISH