Gardena city gardening Instrucciones De Empleo página 13

To connect the drip heads to the supply pipes
[ Fig. I3 ]:
CAUTION!
The first drip head should be placed directly
above the water surface in the container (see
Fig. O2 / O3). This serves to ventilate the system
and prevents any after­running of the water after
the system has been switched off, especially in the
case of drip heads located below the water level.
1. Cut off the supply pipe
point of the drip head
2. Slide the supply pipe
(5)
the drip head .
4 . OPERATION
DANGER! Risk of injury!
Injury when the product starts accidentally.
v Disconnect the product from the mains before
you fill the container.
Watering programs [ Fig. O1 ]:
The watering programs can be set by the rotary switch
on the watering control. The watering duration is repeated
at the set watering frequency.
Program table
Rotary switch Watering frequency and Watering duration
position
OFF
No watering
One-time watering for 3 minutes
4 h 6 min Every 4 hours for 6 minutes
6 h 6 min Every 6 hours for 6 minutes
8 h 1 min Every 8 hours for 1 minute
8 h 3 min Every 8 hours for 3 minutes
8 h 6 min Every 8 hours for 6 minutes
12 h 1 min Every 12 hours for 1 minute
12 h 3 min Every 12 hours for 3 minutes
12 h 6 min Every 12 hours for 6 minutes
24 h 1 min Every day for 1 minute
24 h 3 min Every day for 3 minutes
24 h 6 min Every day for 6 minutes
48 h 3 min Every 2nd day for 3 minutes
48 h 6 min Every 2nd day for 6 minutes
72 h 6 min Every 3rd day for 6 minutes
GAR_01407-20.960.17_2024-06-19.indb 13 GAR_01407-20.960.17_2024-06-19.indb 13
(3)
vertically at the installation
(5) .
(3)
fully onto the connection of
3. Slide the other end of the supply pipe
other connection of the drip head
4. Repeat steps 1 to 3 until all drip heads
connected.
5. Slide the end cap (9)
(5)
last drip head .
To assemble the pipe pegs [ Fig. O2 ]:
We recommend the assembly of 3 pipe pegs per 1 m long
flower box.
1. Insert the tube holders
soil of the flower box.
2. Clamp the supply tube
Note:
Art. 1407: A drip head dropper has a flow rate of
approx. 2 litres per hour.
Art. 13158: Each outlet of a drip tube has a flow rate
of approx. 1.6 litres per hour.
(11)
(3)
fully on the
(5) .
(5)
are
onto the free connection of the
(4)
in the desired positions in the
(3) (4)
into the pipe pegs .
Litres per day and drip head /
outlet approx.
Art. 1407 Art. 13158
0.1 litres 0.07 litres
1.2 litres 0.9 litres
0.8 litres 0.6 litres
0.1 litres 0.07 litres
0.3 litres 0.22 litres
0.6 litres 0.45 litres
0.07 litres 0.05 litres
0.2 litres 0.15 litres
0.4 litres 0.3 litres
0.03 litres 0.02 litres
0.1 litres 0.07 litres
0.2 litres 0.15 litres
0.05 litres 0.04 litres
0.1 litres 0.07 litres
0.07 litres 0.05 litres
19.06.24 20:54 19.06.24 20:54
13